如何启用SAP CRM附件UI上的advanced按钮

As the steps are a little bit tricky, I use the working UI component SMCOV and SMCCMBO to illustrate. After Advanced button is clicked:

 

 

Step1: The navigation link of SMCCMBO is triggered, navigation link 2ADDDOC:

 

 

So define the similar navigation link with EXACTLY the NAME 2ADDDOC in your own wrapper component like SMCCMBO:

 

 

Since the navigation target is SMCCMBO/MainWindow, its inbound plug 2ADDDOC will be called:

 

 

Step2: You should implement the inbound plug like below:

 

 

the outbound plug should be implemented like below, use exactly the name TODOC_ADDDOC.

 

 

Then define the navigation link TODOC_ADDDOC in your UI component which holds overview page, in my case, SMCOV.

Note: DO NOT define it in your wrapper component ( SMCCMBO) !!

 

 

Step3: Now inbound plug ADDDOC of SMCCMBO/DetailWindow will be called:

 

 

So you should implement the inbound plug IP_ADDDOC as below:

 

 

Also implement the outbound plug OP_TO_ADDDOC in detail window as below, use exactly the name TO_ADDDOC in line 3.

 

 

This means you should define the navigation link TO_ADDDOC in wrapper component SMCCMBO.

 

 

Now the navigation target is AttachmentProperty.MainWindow, inbound plug 2ADDDOC.

 

 

Step4: Actually our development finished till step3. From this step, the execution is within Content management's code.

 

 

Here we can observe the navigation link NL_2ADDDOC finally points to advanced page.

 

 

要获取更多Jerry的原创文章，请关注公众号"汪子熙":