Could not load definitions from resource net/sf/antcontrib/antcontrib.properties. It could not be found.
failed to create task or type if
解决方法:
一、到
http://sourceforge.net/projects/ant-contrib/files/ant-contrib/下载nt-contrib-0.6.jar，
二、在window --> preferences --> Ant --> Runtime --> Classpath中选择Global Entries,然后添加ant-contrib-0.6.jar文件即可,以便eclipse在运行ant任务时会加载ant-contrib-0.6.jar,这样就可以解决上述问题现象,其实这里也可以将ant-contrib-0.6.jar文件放在Ant Home Entries,但这样有可能造成与Ant本身包的混淆.
分享到：
相关推荐
impl.xml:127: Could not create task or type of type: junit. <br> Ant could not find the task or a class this task relies upon. <br>Suggestions: - for Ant 1.5.x and previous, make sure ...
You can use Word-2-CHM command line when you need Word-2-CHM to create CHM file automatically for you in batch file, or in scheduled task, etc. The command line of Word-2-CHM is as below: Word-2-CHM....
In earlier revisions, the error status light was cleared after a VsSetWavelength() call failed, so the user did not see the light turn red to alert that an error had occurred. This has been fixed in ...
Prior to delivering this material, test the class to see if they fully understand the different isolation levels. If the class is not confident in their understanding, review appendix A04_Locking and ...
Note: If the connection to the NetLink is disturbed, the driver starts in demo mode, because it can't read out the licence code. If afterwards the connection to the Netlink can be established, the ...
If a message is printed about a failed test or a traceback or core dump is produced, something is wrong. On some Linux systems (those that are not yet using glibc 6), test_strftime fails due to a non-...
(^- create this in an editor with some more or less intelligent Search抧扲eplace steps) 'Function Renamer' If you decompiled a file that was obfuscated all variable and function got lost. Is ...
devices (currently only used to set the speed reported by device and to specify an alternative redolog file of USB MSD disk image modes) - hard drive - new disk image mode 'vvfat' - ported the ...
2.Add exported macro "USESPI" to choose if use SPI to drive LCD or not. 3.After several days researching about hard SPI to drive LCD, failed. So switch to use a faster GPIO method, as below: ...
先选责需要另存图层的要素（直接选择或者属性表），然后在图层上右键Selection/create Layer From Selected Features。 (以前都是直接export竟然没有发现) 27.利用Hyperlinks丰富数据库，为其添加超链接。 单击...